The Best Method To Clean Your Glass Bowl Period.

[Monsterweed]

I just did this to my bowl and the results are fucking superb!

1. Fill a jar with water.
2. Put in microwave for 1:50
3. Microwave jar for 30 seconds more
4. CAREFULLY REMOVE JAR [ITS GONNA BE FUCKING HOT]
5. Add a generous amount of LIQUID Cascade dish washing detergent
6. Place back in microwave for 1:20
7. CAREFULLY REMOVE JAR AGAIN [ITS GONNA BE FUCKING HOT]
8. Stir any left over detergent to mix.
9. GENTLY place bowl in jar.

After about 2 minutes almost my entire bowl was crystal clear, and looked brand new. There was some stubborn resin stuck inside, but all you have to do is submerge that area and shake it a bit without hitting the sides.

You should probably also rinse it after, just to be safe kids haha.

Goodluck

 

[mvg26]

rubbing alcohol and epsom salt works pretty good as well and you dont have to deal with hot ass liquids, not too mention moving a glass piece from cold to hot and back to cold isnt good, the expansion and contraction can break glass pieces ive seen it happen

 

[chronicle]

yup rubbing alcohol works great, just fill your bowl/bubbler with it and add a lil hot water and shake it around violently for awhile and it cleans it perfectly

 

[wafflehouselover]

No unleast you have a Pyrex

 

[scytzoh]

u guys are messed up

 

[PlatinumKasse]

dude there's one solution... simply the best, 420 cleaner.

 

[roug314]

yea 420 cleaner works, it is also just pretty much just rubbing alcohol and salt with a higher price tag.

 

[thenextlevel]

this would be good. just note you should rinse with hot water afterwards. as mentioned above, glass does not like drastic change like that.

 

[thegtiguy]

I use alcohol and rock salt. Shake your piece with the rock salt and alcohol inside, the rock salt scrapes all the resin and nasty off the interior. It is best done after you boil the bowl. As long as you don't put it under cold water while its still screaming hot, it wont crack.

 

[daveg1i]

another cheap option is nail polish remover, its like .99 cents and it works the balls. that how ive always dont it, then obviosly run water through it and your good to go.

 

[Pizzzh]

i use a bobby pin go in throu the carb usually scrape all of it out roll it up in a ball and smoke it... resin gives you a nice body buzz.. i wouldnt waste it

 

[daveg1i]

dude back in the day when i couldnt get weed readily yea i smoked resin, not anymore though. it aint worth it, you clean out the bowl then put the resin back in it and clog it back up again, fugg dat...

 

[gardenandcats]

Zip lock bag put in your bowl rubbing
alchohol a few tablespoons of salt let it sit for a while shake a few times gently and its usually clean..Rinse well under warm water..

 

[abudsmoker]

LOL i use a blow troch and unleaded gas. works perfect***** lol

i screwed up on step one and cooked it for 4:20 figures....

 

[abudsmoker]

dude back in the day when i couldnt get weed readily yea i smoked resin, not anymore though. it aint worth it, you clean out the bowl then put the resin back in it and clog it back up again, fugg dat...

let alone the shittest taste you can imagine

 

[rastahockey]

let alone the shittest taste you can imagine

That's when you just knife hit that hoe...

 

[abudsmoker]

That's when you just knife hit that hoe...

No just just visit your capitol city if you know what i mean

 

[brn1down]

works like a charm..only other thing i used an old brush to get out the stubborn points

 

[potheadsmoker]

NON-SENSE, heres the best way to go about this no nasty salt to fuck with no weak alcohol....simply soak in acetone take the liquid pour it out onto a pyrex dish let the shit evaporate, then you got yourself some nice joint spread...i seen a post about epsom salt and rubbing alcohol, if you do anything with the 2 go ahead and take your epsom salt bake it for 2 hours at 400 degrees you end up with magnesium sulfate, take that poura bit into your alcohol shake the shit out of it for about 5 minutes let it sit for about another 5 minutes or until everything is settled at the bottom it should look sorta like white gel filter your alcohol thru a coffee filter...take a little mag sulf. and if it falls rapidly the alcohol is still "wet"(has water in it still) if it falls like snow flakes it is "dry". if it is dry filter again if it is not repeat the process over until it is dry....now what you have is 100% pure isopranol now use that shit to clean your pipe.

 

[potheadsmoker]

now you get the best of both worlds, your pipe is clean and you also get to smoke some resin laced joints... i have provided you with the "raft", now its up to you to "inflate" it