Bob Bitchen's buds

[hyroot]

Vegas time!

I am going to make a new lid for my cloner. Less spots with bigger inserts. I will check Kohls cooking section to see if they have some good cutting board material. Or maybe I will check out State College and see if I can pick up a scrap piece of Corian.

wouldn't that be a bit heavy. Alot more work. Why not a sheet of plastic poly what ever or fiberglass.

I haven't been to Vegas in so long. Too much to do and not enough loot for Vegas right now. Maybe in a few months. I plan on road tripping up north them though. Griswald style

 

[Dr.D81]

I want to take a Vagus trip bad. I would love to come home with a cut of that too strong purple kush they have there

Bob i am a dumb ass i knew that

 

[SomeGuy]

I lived in Vegas for a while. . Still have good friends there.

 

[Mohican]

Thanks but too late. I got a new piece and it is cut and polished. Now I just need to place the holes.

Something like this:




Cheers,
Mo

 

[Dloomis514]

Thanks but too late. I got a new piece and it is cut and polished. Now I just need to place the holes.

Something like this:




Cheers,
Mo

Something about that layout doesn't look symmetrical, was that intentional? The top 7 black circles seem to have to large a gap between the bottom 7. Maybe the bottom and top 3 have an irregular spacing.

 

[Mohican]

There will be a handle in the middle for lifting the lid. I am still working on what I want there. I revised the pattern:




Cheers,
Mo

 

[Dloomis514]

I bet if you move the ones on the right and left middle positions slightly toward the center, symmetry will be achieved.

 

[glockdoc]

i think they are both already symmetrical...no?!?

 

[Javadog]

I am having a "Monk Moment" too...I am sure that they are not 100%
aligned, but even moreso that any tweaking by me would only make
matters worse.

 

[glockdoc]

if you were to cut that in half both ways, they look exact.

 

[Dloomis514]

I bet if you move the ones on the right and left middle positions slightly toward the center, symmetry will be achieved.

Here is a site to get recommended spacing of circles on rectangles, interesting.

http://www.engineeringtoolbox.com/circles-within-rectangle-d_1905.html

 

[Mohican]

Top is finished (except for the handle)

Old Top




New Top




Cheers,
Mo

 

[BobBitchen]

looks good Mo.
I did my DIY lid 16 site x 1 3/4in puks, used black for light block

 

[BobBitchen]

rolled a J of the Cherry Pie last night did not disappoint, knocked my ass out !! smooth & tasty s/b great after a bit in jars

 

[BobBitchen]

topped & ready for up potting

 

[genuity]

It's bout to get funktasic up in that room...so lush and green.

 

[Mohican]

What are they?

 

[BobBitchen]

What are they?

Dog Treats,
Honeybee,
GDP x Honeybee
( Purple wreck x OG ) x ?

Top 2 are @genuity
bottom 2 @Dr.D81

 

[BobBitchen]

re-testing Cherry Pie...........

 

[Dr.D81]

Hold up you better do it again