I am useing Pure blend but I am trying another fert on 4 Plants in veg (synthitics )

hey ganjababy,
do you mix it at full recomended strength??

__________________
noob 4 life

yes, I feed every watering at 30ml per gallon for flowering and for veg I use no more than 30ml per gallon. I used full strength flowering nutes for a clone and it didn't burn it. Also I add 1 tablespoon of unusulphured molasses for one gallon of water once a week after the transition.

I use for flowering floralicious bloom from general hydroponic and for veg...pure blend pro grow and i mix this nuts..if i flowering it making magics...Grow fast and big.

__________________
STOP ARRESTING SMOKERS!!!!!

I got a hot tip on here to use the Pure Blend Pro Bloom for the entire time and forget the grow version. I been doing that and havent used the grow in quite a while. The plants seem to be doing fine. I think maybe you might want to re-read the label directions. Seems like the the 1 oz increment is for 5 gallons of water as opposed to 1 gallon. I been using 1 capful per gallon and all seems well thus far. Notice the nitrogen levels arent much different on either the Grow or the Bloom which got me sorta cornfused when I bought the stuff. Best of fortunes to you and your grow.

Big Wheel

right on. it's good to know that there feeding schedule for soil is pretty good.

thx
f

__________________
noob 4 life

No, you might want to reread the feeding charts, they say 1 tablespoon (30ml per gallon) for 4 liters of water for full bloom.

OK... so I suck at the metric system.... but according to the online conversion calculator I used 30 ML converts to 2.028 tablespoons... not 1.

Anyhooooo.... sounds like you have it all under control for soil....

I just want the hydo growers to be aware that the feeding instructions are wrong for hydro. Even at 1 tablespoon per gallon the PPM is through the roof. I have a 13 gallon reservoir that I usually fill to 10 gallons. I use 2 tablespoons (total) of the pure blend pro grow and my PPM is around 950. Of course my tap water starts off with a PPM of about 400 so that is also a contributing factor. Even so... for Hydro 1 Tablespoon per gallon is going to be way too high.

__________________
*´¨)
¸.·´¸.·*´¨) ¸.·*¨)
(¸.·´ (¸.·´ FL Girl

you're right that was a typo, 1 tablespoon is 15 ml, I meant to say I use 2 tablespoon per gallon...

Holy shit!!! That just goes to show the huge difference between Soil and Hydro. 2 tablespoons (PureBlend Pro Grow) per gallon in Hydro would kill the plants.

Before I was monitoring my PPM I just followed the directions and backed off a little .... thinking I would be going easy on the nutes. I used 6 tablespoons to 10 gallons of water. After my plants suffered severe burns.... I started monitoring the PPM..... at that strength I found the PPM shot up right past 2000 PPM (my meter only goes to 2000).

Got it all worked out now and found that 2 tablespoons to 10 gallons of water is the right mix for my water.

I must say that I am very disappointed that the package feeding instructions could be so far off (for hydro). I'm going to finish this grow with these nutes... but I read another thread praising the Dutch Master Gold nutes and I'm going to give them a try with my next grow.

__________________
*´¨)
¸.·´¸.·*´¨) ¸.·*¨)
(¸.·´ (¸.·´ FL Girl