hi to all i need help with the mixes of the general hydroponics nutes flora series .... i have the 3 colors , the micro , grow , and bloom ... somebody than can help me wich are the measures for vegetation , for transition and for bloom ... i have the plans in ebb n flow with grodan rockwool 6 inches ... the reservoir is 260liters.... help me pleasee i will to appreciate so much

did somebody say i?? jejjjeje

here you go
3253997406_be4ab98eca_o.jpg

Check it out.

Grow micro bloom right? This is what I use.

Grow is for veg, micro is the whole time. Bloom is for blooming/flowering.

You will most likely use heavy grown, medium micro, light bloom for vegging, then for flowering, you will most likely use light grow, medium micro, and heavy bloom.

Get it?

For more specific answers, I need more information. How many plants, what medium, how big of a resevoir are you mixing in.

On a note, the charts on GenHydro are mostely shit. Use the calculator on http://genhydro.com/calculator it can help a lot, but is still only a guide post.

I see your measurements. Are you recirculating or throwing away your water every time? Do you have anything else besides the 3 part? Remember, the charts they have at gen hyrdro are generic, good somewhat, but generic. Pot and Tomotos are not the same.

Also, are you doing basic, agressive, transisions etc? Do you rodi your water, or is it tap, or well water? Ebb N Flow, is it a table?

hi doctor .... yes i am recirculating water . i use well water , it have 033ppm , i have on a table ebb n flow 9 plants , my reservor is 260lts , the first mix was 500ml of micro , 500 of gro and 500of bloom ... and it result 1100ppm for vegetation