General Marijuana Growing
Pinching The Tops in the
The Grow Room forums; If I pinch the tops, would that create better results? If so, what week should I do it? ...
Pinching The Tops
If I pinch the tops, would that create better results? If so, what week should I do it?
Topping, Pruning, Fimming
Essentially they are the same, "Pruning" and "Topping", just two different commonly words used. Fimming means a lot of indesriminate Topping. It is also known to some as "Pinching" as well. In this page it will be refered to it as "Topping"
Topping is done to increase yield and make them bushy, bushy, bushy, make more buds, promote "branching", and increase the overall yeilds of the plants. With higher overall yeilds, a grower will successfully harvest many more budds, or floral clusters, and from smaller, bushier and more compact plants.
To the indoor grower that does not use this technique, but allows their plants to grow tall, it can be a waste of their artificial lighting, and growing spaces potential. With its own natural growth pattern, and without the benifit of topping, your lady will have one main central "khola" budd, at peak flowering. Several other small branches will grow outwards, down its main stalk, with much smaller budd topps.
The natural growth pattern is to grow upwards at its main stalk. From this main central stalk will begin to grow side branches. The side branches come out as tiny shoots with leaves, and usually there are a pair of them on opposite sides of the main central stalk.
When the seed leaves have long dyed off on the main stalk. The first true seed leaves commonly can or will, wilt, dry up, or dye off of the plant as well. (the little round ones) Once healthy new vegative growth begins the rate of growth can be very fast, with excellent lighting supplied.
As the new growth increases the light reaching the lower portions of the plants becomes less. Thus it is common to see first leafs wilting and dying ect. Growers that see leaves wilting or dying, ect, will opt to pulling them off of the plants. It is cool to remvoe dying, yellowing unhelathy leaves. I NEVER remove a helathy leaf.
The main central stalk is topped of just above the branches that are coming out below it. A pair of scissors is best be used.
There are no rules to where you top your plant or how old it needs to be. As long as your plant has shoots protruding further down the main stalk it is able to be topped. When topped the growth of the plant will be concentrated towards the new, younger vegative shoots.
Once you have topped your plant(s) the younger shoots will rapidly begin growing. With the removal of the main central stalk the lower braches grow more. With topping completed we keep the plants on their regular lighting and feeding schedules.
Now each new shoot tip will essentially grow as the main stalk did, however the growth is not concentrated to only one central stalk. So as each new shoot grows outward new shoots will grow from each one of them stalks as well.
Therefore topping can be done again, and again, and as each shoot becomes a growing tip with other shoots forming down its stalk, it is removed. By completing these topping or pruning tactics, a grower can acheive any desired height, or desired bushiness, they desire in their plants.
I TOP and FIM, at the 2nd, 3rd, and 4th week, (I do a rapid Hydro grow) . Look at the results in the pic of my dozen stalks.
With pre-planned Topping and Prunning, I was able to persuade a plant to make 12 or 13, (depending on how you count them) to produce 12 or 13 stalks. got about 46 inches tall, and produced 7 ounces of dried manicured buds.
A friend named Mogie gave this to me:
Topping a Plant
1. Locate the very top of your plant and cut through the main stem just below the newest growth. This should be done after the 3rd or 4th leaf set but can be done at any time after the 3rd leaf set.
2. Shows Plant Top cut off and where the 2 new Branches that will form a "Y" in the main stem will grow from.
3. Shows the newly topped plant after 2 days of growth, notice the Y in the Stem Forming.
FIMMING A PLANT!
Fimming is actually no different that topping, what fimming does is virtually the exact same thing only your leaving part of the new growth. This only takes of part of the new growth and actually topping the very very new growth which is very hard to see.
What this ends up doing is making it seem as if your getting 4 new tops right next to eachother when its actually only 2 at the very top (like topping) but since it was cut so closely to the next newest set of fanleaves 2 branches which would have formed there anyways seems to make it look like there is 4 new tops.
This is how you go about doing this.
1. Locate the very top of the new growth
2. With a clean sterilized scissors, Fold the fan leafs over and cut approximately 80% of the new growth off the plant.
3. View from the top showing the Cut
4. View of the Cut section after 2 days growth, showing the 4 new growth shoots (branches)
By johndoe134 in forum Marijuana Plant Problems
Last Post: 11-20-2009, 02:42 PM
By GodofGraphics in forum Newbie Central
Last Post: 07-15-2009, 12:31 AM
By Bdoo in forum Harvesting And Curing
Last Post: 10-05-2007, 09:23 AM
By jaymoney151 in forum General Marijuana Growing
Last Post: 06-28-2007, 11:10 PM
By mal_crane in forum Newbie Central
Last Post: 12-06-2006, 04:23 PM
Tags for this Thread