Need some advice for my grow room - PICS

**itsalways420** · 08-16-2009, 08:45 AM

Hey everyone, so I am putting in a grow room in my closet, i just took out all the shelving, and I am starting to build the frame. Frame will be 7ft tall, by 30 in deep by 8ft wide. The closet is about 2 inches bigger on each side and 10 inches higher thank the frame.

Here are a few pics of the beginning of it.

The other side inside looks the same. I am going to have 2 rooms, 1 for mothers and cloning above the mothers on a shelf, and the veg & flower room.

I need some advice ppl please, I am going to get some panda film, and rap the entire frame in it, but what would be the best way to attach it to the PVC?

I will be venting into the attic, so ventilation will not be a problem, I have a 600w cool tube with elec ballast for the V & F room, and a 2 300w CFL and 2 150w CFL's in the mother room.

What do you think is the best way to set the filter and ducting up if I have 2 attached rooms?

Any other advice, it is welcomed. ...

thanks

**itsalways420** · 08-16-2009, 10:24 AM

25 views and Not 1 piece of advice from any experienced growers huh?

Illegal Smile · 08-16-2009, 11:02 AM

Your post was kinda hard to digest, too much info scattered around. Remember, we are at least as stones as you are! Is the only Q about ducting and what's going on with two rooms again? What's the #1 problem? Then go to #2.

**itsalways420** · 08-16-2009, 03:18 PM

Originally Posted by Illegal Smile

Your post was kinda hard to digest, too much info scattered around. Remember, we are at least as stones as you are! Is the only Q about ducting and what's going on with two rooms again? What's the #1 problem? Then go to #2.

hehe, what's the best way to attach panda film (or something comparable) to PVC.

**hayzeheven** · 08-16-2009, 03:31 PM

Originally Posted by itsalways420

hehe, what's the best way to attach panda film (or something comparable) to PVC.

use poly film (panda) n just wrap that bitch up n tape it lol

**h8popo** · 08-16-2009, 03:31 PM

i dont get why you are making it all out of pvc. a wood frame would be your best bet. i would shit can that pvc and get some 2x4's and plywood. and your veg plants need to be with your mothers. the flower room is just that.

**hayzeheven** · 08-16-2009, 03:33 PM

theres no problem with pvc, its not like hes goin above 150 degrees to where maybe the pvc might give off a foul odor, or mild gas.. pvc is much easier to make a nice tent out of, easier to take apart too

**h8popo** · 08-16-2009, 03:41 PM

Originally Posted by hayzeheven

theres no problem with pvc, its not like hes goin above 150 degrees to where maybe the pvc might give off a foul odor, or mild gas.. pvc is much easier to make a nice tent out of, easier to take apart too

ohhh i didnt think of wrapping a tent around it. now i see what hes going for. i would just use the whole closet as the room. partition off the two areas and call it a day. put the mylar or whatever right on the wall.

**hayzeheven** · 08-16-2009, 03:46 PM

yea actually thats what i was gonna say lol, i mean it would makes sense if he was making a tent HALF the size of the closet to build a frame.. but uh.. its the whole closet... so i don't see why he doesnt take some two sided tape or some 3M spray on adhesive, n just stick it to the wall like u said h8popo... (btw i hate 'em too).. cuz its not like he plans on using the pvc for support, being as it wont give any for lights.. idk.. y did u chose this method itsalways420?

**h8popo** · 08-16-2009, 05:04 PM

think you should rethink your plan a bit... my whole setup is under a staircase. 2x4s and plywood was my best friend. if you need a shelf and what not in there, pvc isnt going to cut it. it will be weak and a rickidy p.o.s. not tryin to shit on your setup, just tryin to help ya out.