| Forum | Shop | Market | ![]() |
Seeds | FAQ | Tools |
SEE OUR MARIJUANA SEED GUIDE FOR THE BEST STRAINS |
Looking for Legal Marijuana look no further! |
|||||
|
#1
|
||||||||||||
|
||||||||||||
|
Wuddup guys -
I just thought i would share my method of germing with all of you, because ive had 100% success with all my germs except for a couple that i did that i DIDNT use this chamber with. they ended up dying right after the taproot shot out, because there was too much heat coming off of my cable box, and it killed them. This box is easy to make, all youll need is: 1 - plastic picnic plate with three sections in it 2 - electrical tape 3 - duct tape 4 - skissors i couldnt find my electrical tape, but the picture is just to show u what kind of plate you need. ![]() Step 1 - Its a pain in the ass to do, but take a STRONG pair of scissors, and cut the plate in half, seperating the large section from the two smaller ones. then, procees to seperate the two smaller sections from each other, and then remove the lip from around the edges of both sections. you should now at this point have thrown away the larger section of the plate, and have two seperate smaller sections with all sharp edges and lips trimmed off, so you basically have two plastic pieces that fit together reasonably well. - sorry i dont have a pic for what it looks like at this point, i aint makin another damnit, i already have 3 or 4, lol. Ok, so at this point, all you need to do, is wrap the outside of both halves in electrical tape, so that it blocks all light from getting into your box. Wrap both pieces in electrical tape, and make sure that you get all of the edges and corners. make sure its evenly wrapped or it wont fit together properly when you put the two halves together. Once youve done that sufficiently, place one half on top of the other, to form a box - it should fit pretty well at this point. Take some duct tape, and tape the back of the box, just basically making a hinge more or less, so that the front of your box cracks open, but doesnt really open all the way. this helps to prevent light also. after that, the end result should look like this: ![]() - i know it aint nothin special, but it does work every time, and it keeps the heat from directly touching your seeds, and it blocks all light from getting into the box and onto your seed while germing, even if the box is sitting out in plain view in direct light, it still wont penetrate the box. Its an easy fix for alot of peoples germing problems. - at this point, all you need to do from here is take a soaked paper towel, fold it in half, pop your seed into it, fold it again evenly, so you have two layers above and below your seeds, and pop it into the box. hope this helps some of the people out there who have troubles germing their seeds. N u can reuse them, and also make several of them so you never mix up your seeds or confuse them again. -K1.
__________________
UPDATE! Ebb/Flow monster ScrOG sorta thing(latest update): http://www.rollitup.org/grow-journal...-hehe-155.html -LastPostOnPage- Elite Genetics OG Kush Beta test Grow & TGA Space Queen run --4 strains will make a TON of moms!!! http://www.rollitup.org/grow-journal...-beta-run.html |
| Tags |
| chamber, germination, make, single, strain |
| Thread Tools | |
| Display Modes | |
|
|
Thread |
Thread Starter |
Forum |
Replies |
Last Post |
| A single calyx with a single pistil at every internode.. | ivebeencanceled | General Marijuana Growing | 32 | 08-17-2008 02:23 PM |
| Germination bad strain? | JiggyJogger | Newbie Central | 3 | 06-20-2008 01:29 PM |
| Need some advice on a strain for a single cola ebb and flow system | Cst4r | Hydroponics / Aeroponics | 0 | 12-04-2007 10:17 PM |
| How To Make Germination Faster | MAG1C | Indoor Growing | 2 | 06-08-2007 11:47 AM |
| Can I grow more than one strain in the same hydro chamber? | 462HDME | Newbie Central | 4 | 12-16-2006 10:35 PM |
Come Check out a new Poker Forum for the online poker community