Roseman's DIY Bubbleponics Tutorial - Page 3

Roseman · #21 08-29-2009, 02:32 PM

Time to check out my Irrigation Hubs, also called Irigation Manifolds.
To clean them, I start reeming them with a piece of wire, and then use a can of compressed air to clean them. Then I always reem them out good with a 1/16 drill bit, then do them again with a 5/64 drill bit. I want to make sure each outlet is not clogged up. I do not want a big stream or flow of water, I only want a slight trickle.

Of course this is not necesary if you start with a NEW pump or hub.

They appear to be unclogged and working great after I cleaned them! Before I cleaned them, half the outlets were clogged.

You see a FLOW or a stream in these pics, but after the water pumps are also drawing in BUBBLES, there will be more of a trickle than a stream of water.

I am glad I had the electric drill, the can of compressed air and the small wire to clean them with.

Roseman · #22 08-29-2009, 02:33 PM

Now I am going to soak my water pumps in some pH balanced water. Those filters in the pumps might still have a speck of root in them, and that would sure cause havoc to my pH later.

Roseman · #23 08-29-2009, 02:34 PM

A couple years ago, I went to Lowes and bought two feet lenghts of 1/2 inch, 3/4 inch and one inch clear pastic tubing. Each tube will very tighly and snuggly fit into the next bigger size and I use them to connect my water pumps to the Irrigation Hubs. I can cut them to the needed lenght and they fit just right on any brand of pump or irrigation manifold.

I also use the one inch tube to drain my tanks.

Roseman · #24 08-29-2009, 02:35 PM

If you have to ask questions, or start a discussion off topic, go here:

Questions about Bubbleponic Growing Thread
__________________
Please do not hi-jack this thread and start discussions off topic. Hi-jacking someone elses thead to start a discussuion is considered RUDE.

QUESTIONS will be answered faster here:

Questions about Bubbleponic Growing Thread
.

Roseman · #25 08-29-2009, 02:40 PM

OK, the third pump, a new one, will go into the DIY 5 gallon bucket.

I checked the Irrigation Hub and it works fine. I used a 7 inch long 3/4 inch plastic tube to attach the pump to the Hub. That is a customized fit for my 5 gallon bucket. After I tested it and put it in the bucket, I saw 7 inches was too long, so I cut it back to 4 inches.

The KIT comes with what you need to attach the pump to the hub.

If you buy the kit, the hub and pump come matched up and already fit together.
If you DIY, you will need to rig up something between the pump and hub, and I think using the clear plastic tubes work best. Certainly cheap and easy enough.
ALL water pumps come with several attachements just for this purpose.
These pics show a strong stream of water coming from the tubes because the pump is not drawing in a lot of AIR like it will in the tank. Then, the tubes will emit a bubbley trickle.

I had used a 7 inch piece of clear plastic in those pics to connect the pump to the hub, but when I tried it in the bucket, it was too tall, so I went back and cut it down to 4 inches.

Roseman · #26 08-29-2009, 02:41 PM

I got the pumps and hubs all cleaned and I hope I start the seeds soaking and germinating soon.

Let me remind you that IF you are using a New Kit, you can avoid most of the work I have detailed thus far. I am working with OLD, USED equipment and having to clean it up and prepare it for another grow. I did buy new tubes and air stones.

I am also trying to detail a DIY HOW TO using a 5 gallon bucket grow, with 3 grow cups.

I bought my bucket for $5.00 and the lid was $2 extra. The 3.75 inch grow cups were about 60 cents each.
The grow cups are perfect for hydroponic growing, being like little baskets that allow air and water to flow through the roots.

First I get the lid and a grow cup and a black magic marker.
I am using what was called a 3.75 inch grow cup. It is actually 4 inches wide at the widest and it fits into a hole 3.5 to 3.75 inches wide.
Here I am tracing my grow cup with a black magic marker.

After I trace the three holes, I go back and make an inside circle that is 1/4 inch narrower.

I am using a DREMEL power hand tool, to cut the holes. You could use a razor knife or a heated knife blade or a hole cutter from the hardware store.

Roseman · #27 08-29-2009, 02:41 PM

Now I take my drill, and make a hole very near the top, actually two holes, leaving enough room for the lid to fit on the bucket, but not too low. These are holes for the air stone tubes.

One hole on both sides of the bucket. I could have put them closer to each other.

Now I cut a hole for the Water pump wire.

And Ta Da!

My DIY 5 gallon grow bucket.

Roseman · #28 08-29-2009, 02:42 PM

QUESTION:
What is with the Water Pumps and Irrigation Hubs?

ANSWER:
One word, BUBBLEPONICS!

I could copy and paste a bunch of technical info here but I'm trying to keep it simple. Earlier, I explained the different Hydroponic systems, and this is about Bubbleponics, the very most efficient fastest growing hydroponic system available. The word BUBBPLEPONICS is actually registered and owned by a friend of mine that owns Stealth Hydroponics.
Simply, it is a system of pumping oxygen enriched and nutrient enriched water to each root base, even when there is no root base and the seed is first germinating and starting its first single root. It is not a stream or strong flow of water, that would drown the sprout. It is just a trickle of a lot of air and a little water, rich in nutrients. As the water is trickled onto the base of the sprout, the roots are fed and then they follow the trickle of water as it falls into the bottom of the tank and re-circulated. The airstones provide a lot of oxygen to the water and the water pump then pumps that oxygen and water to each sprout.
The water pump also moves and stirs the water, and we all know stirring water is cooler and more oxyegenated as it is moved.
I could go on and on, explaining, but the real explanation is in witnessing the rapid growth, especially the first 3 or 4 weeks. I actually have to raise my lights an inch higher every day due to the rapid growth, the first 4 weeks.

To believe it, you will have to see it.

ten days

12 days

15 days

17 days

20 days

I started 3 seeds in soil the same day, to make a comparison, as you see in the pics.

Those first 3 weeks is when the feeding tubes really make a difference.

I started seeds in the soil and in the Bubbleponics system at the same time in these pics. See any difference?

BTW, never bring soil near the Hydro system. I should have never done that. There is a danger of bugs and bug eggs in the soil getting to the baby plants.

Roseman · #29 08-29-2009, 02:43 PM

I am rinsing my tanks and bucket very good with hot water, they have to be clean, then I am rinsing them again by wiping them down with a thick paper towel full of vinegar.
Then I wipe them dry again.

See the extra holes in the ends of the tank, for adding extra air hoses and air stones:

I cut out that little 1/2 inch cut out to put my wire that runs to the water pump, making it easier to close the lid.

And here you see the black magic marker line I made to show me the 6 gallon water level line.

Roseman · #30 08-29-2009, 02:44 PM

Here, I am cutting my tubes to a 12 inch lenght, to run each from the Irrigation Hub to the Grow Cups. I will probably trim them shorter later when I attach them. They should not all be the same lenght. The cneter ones can be just 7 inches long.
And again, if you bought the kit, they come already cut and attached. My old lines were full of calcium and lime deposits, commonly called water salts or water minerals, so I bought new tubing.

I needed SIX for each tank or bucket.

Attached Thumbnails

Forum	Shop	Market		Seeds	FAQ	Tools
SEE OUR MARIJUANA SEED GUIDE FOR THE BEST STRAINS				Looking for Legal Marijuana look no further!

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Thread	Thread Starter	Forum	Replies	Last Post
Stealth Hydro Bubbleponics Systems	Roseman	DWC/ Bubbleponics	17304	11-21-2009 09:56 PM
Diy bubbleponics	Roseman	DWC/ Bubbleponics	562	10-16-2009 09:17 AM
first grow diy stealth bubbleponics 400w hps	sucio805@yahoo.com	DWC/ Bubbleponics	14	09-02-2009 08:56 PM
Roseman's Closet-Grow Tutorial	Roseman	DWC/ Bubbleponics	220	08-30-2009 02:31 PM
diy bubbleponics system	six8	Hydroponics / Aeroponics	2	04-11-2009 08:15 PM

User Name		Remember Me?
Password

SEE OUR MARIJUANA SEED GUIDE FOR THE BEST STRAINS

Looking for Legal Marijuana look no further!

Thread

Thread Starter

Forum

Replies

Last Post

Posting Rules