So what is the easiest way to make hash out of leaves?

Much appreciation

i have made many different types of hash and i find the easiest is honey oil. it is also one of the purest forms unless you have a 5 bag bubblehash system.. but those cost a few hundread... a copper or stainless steel pipe, some endcaps and some butane cost nothing at all

Here is how I do it picture by picture Blender hash

__________________
Good seed, dirt, light, water, what's the big deal?

so you drill holes in one end of the cap's which is where you put the filter and then one other hole in the oppsite end where butane goes then are you off too the race's or is there more??? edit:just wonna make it right for best produce...the rest i can figure out

__________________
Take everything i say as a joke. All the pictures, text, information i have stolen like everyone else from the internet.

You have to be careful with using butane... not just because it can explode, but because it can remain in your hash if you don't make it right-- and it is said to leave trace chemicals in your lungs.

__________________
speaks louder than words.
Problems on the forum? Contact me here!

thats about it. try to go for standard 3/4" copper, i have used the 3" copper used for old bath tub drains but when i open it up there is always a tunnel blown to the bottom from the prssure of the butane, this is ineffective. The narrower the better.

The only difficult part about it is knowing how much butane to use for what you are using n(leaf, bud, shake...) and how much of it you have. also you need to make sure you buy a butane with no "smell" additives.

see butane in its natural form has next to no smell. But this can be hazardous because if there were ever to be a leak noone would know untill BANG.
you can buy small canisters of butane with next to no additives but you have to know which brand.

a good way to test a product is to spray it on a mirror or glass. if it leaves a "crusty smelly" residue than it is bad to use

hope this helps!

butane will only explode under pressure, what happens is butane is heavier than air and evaporates at a very fast rate. this can cause "pooling" and become dangerous. I have two tips that will make this process 100% safe

1. dont smoke or light anything. common sense

2. do it outdoors on a day with a breeze

if you follow those two simple steps you will be fine

Of course the deposits it leaves in your lungs have nothing to do with anything chuckbane mentioned.

__________________
speaks louder than words.
Problems on the forum? Contact me here!

p.s. i do not recommend this process if you have no common sense...

see above
"also you need to make sure you buy a butane with no "smell" additives."

the residue from good butane is so minimal,, and shit, you ARE smoking,, smoking is bad for your lungs no matter what you are smoking