Concentrates and Extracts
Temps for honeycomb?? please help. in the
Cannabis Cafe forums; What temps should I use if not using a vac 110* and under?
And if using the homemade vac oven ...
Temps for honeycomb?? please help.
What temps should I use if not using a vac 110* and under?
And if using the homemade vac oven should it be 110* and above? And under 131*
I'm shooting for honeycomb crumbly texture.
Please any help is appreciated im making it tomorrow morning
I get it at 90-100F. takes like a week though.
Originally Posted by vacpurge
with the hand pump, pump it as much as you can! set the chamber in a warm environment 90F ish, and let it ride out. (DONT PLACE IN HEAT ABOVE 105f)
i would re pump the chamber daily just to make sure you are at full pump.
for each gram, id say about 3-5 days of purging, good luck! thats all i can give you based on what i have seen
vacpurge it at 130 and just let it run, usually the better the stuff the faster it waxes
First, you must become one with the extract, be, and experience the extract.
Once you've done that...travel down inside the honeycomb hide-out, and ask the honey bee how he built the comb...lol
I'm just fuckin with ya...lol
As Many have said already, patience, patience...do not rush things..
For honeycomb depending on the strain and 1.3 million other variables, low temps are key..I go for 100-105ish
This took 24 hours to ” comb”
Last edited by Sirdabsalot462; 06-20-2013 at 11:49 PM.
The Emerald Rectangle
My Rookie Grow Harvested
24 hours, holy shit!!! at what temp?
I dont know what im doing wrong.. maybe too much butane? chopping it too finely?
So for those of you that do 100-105* is that in a vac chamber?
my 2 stage 6 cfm 10 micron cps vac pump has been running for 24hrs right now, and is at about 120*,, very little reaction is taking place..
but before i got a legit setup, i would just spray onto pyrex and use heat and it would be crumbly in about 5 hrs.
yes. thats IN the chamber... the exact temp of the oil/chamber.. no other way to do it. anything else is inaccurate: I can start at 85F and by the time the vacuum pulls a full vacuum it goes up 5 or 6F in that few seconds JUST from the vacuum. its an instant and very accurate way to tell the temp. no pointing a temp gun at the chamber or griddle and doing some unreliable math to get an approx temp of the oil.
my stuff is a handtouchable paste right now after 24hrs at 120*
im running another batch now, 150grams.
im gonna purge intial liquid tane at 110*, then let sit at 105* for an hour or two,
scrape, make oil muffin,, melt down, and revac...
wish me luck
Also vacpurge what is that temp device ur using sold as?