be nice, he's new
** DO NOT MAKE THIS WITH A GAS STOVE THE VAPORS WILL IGNITE AND EXPLODE**
Hey everybody. My first thread here on rollitup is gonna be a HOW TO on making a smooth and potent concentrate known as "Iso hash" Ive been growing indoor and outdoor for a little over a year and done over 15 strands but to be honest this was my first try at making hash I found it extremely easy and I wish I would have started doing it alot sooner. Thank you for the read, good luck.
1- trim, buds, or hash
2- isopropyl alcohal (for this one I used 50% isopropyl rubbing alcohal but you could use 98% or similar and probably get a stronger yeild; this worked perfect for me. Also, some people say you can use acetone (nail polish remover) instead, I can neither confirm or deny if that works. The alcohal did though)
3- A container capable of holding liquid and sealing. (a mason jar works).
4- A glass tray. (i used a small round one about the size of both hands put together. for bigger amounts you could maybe use a caserole dish. You're going to want to use glass that wont just break from being heated.)
5- A straight edge razor
In your mason jar you will add your trim and isopropyl alcohal until the mixture is thin enough to allow the thc to be seperated from the plant matter. (So a little more alcohal than weed.)
Then you want to stir it around for about 20 minutes before you close the jar.
At this point I enclosed the jar inside of a few bags, then put that in a box. (this is to make sure no light touches the project. It will lower your final THC potency.)
After two days I took the jar out. It should be really dark green maybe even black. Seperate the liquid from the solid and throw away the trim leftover. You should now be left with just this dark liquid.
Add the liquid to the glass tray or casserole dish and put the dish on a warming center or very low heat until all of the alcohal has evaporated from the liquid. You DON'T want to boil this.
You are now left with a sticky yet malleable hashish thats easy to smoke too just scrape it off with the razor and store for usage.
HAPPY SMOKING!! You
be nice, he's new
As a Christian........ we only have ONE fear.
One who can harm the soul.
The flesh is weak.
Idk how to put the pictures up with this but I dont see what you think is wrong with it.
why do you want all the dark gross stuff? everything I read says the thc is in the alcohol within seconds of it touching it. so a quick shake should be good enough. This is all theory and congencture on my part but I do have some iso evaping on top of my fridge right now after a quick shaking. We'll see if it gets you high... I'm not putting my glass bottom bowl on my gas range. Just redid the kitchen and my wife would kill me if I burned it down.
I have only made it 2 times the first time I followed oakleys (if I remember correctly) recipe and it turned out very clean and potent. The second time I figured I could just wing it and did not use measurements and let the alcohol contact the material too long ETC.. long story short I will not do that again. I will however always make a second run at the used material because although it was not as clean there was still plenty of thc to be had. 2 batches does not make me an expert by any stretch of the imagination but I suggest reading a few of the stickies and run a batch where no shaking is involved. I appreciate the fact that you took the time to write out what you have discovered but having went from one extreme to the other I can say for sure that your method is not really the best way to go.
@charface thank you for your input and I agree. Not the best method of creating hash. There are far better ways.
yep char, thatd be me.