Expert with liquid nutrients needed

I use that stuff the guide is right on the bottles. ??????

whatever the dirctions say start at 1/4-1/2 strength. you can always add more.

You can also call general hydroponic and ask to talk to a tech. They will walk you through everything. Great customer service, just don't mention cannabis, they know what your growing so it need not be mentioned!!! I also use GH products and would never stray from them..here are a few of my recent crop..all GHIMAG0462.jpgIMAG0454.jpg

Here is there number 707 824 9376

Soon as you see the second pair of leaves (not including the embryonic set) go with 1/4 strength. I wouldn't wait much longer otherwise you will leach them a bit and as a result they get a slow start. Ditch the grow and just use the micro and bloom. If your water is close to hard (120-199ppm on a hanna .5 conversion scale, for truncheon multiply that ppm by 1.4) dose 15mL/Gal of GH Bloom and 7.5mL/Gal of GH Micro for full strength ( use 1/4 of that in the beginning) res resulting in 941-1020 ppm (.5 conv.) If your water is relatively soft (35-119ppm, .5 conv.) use 16mL/Gal of GH Bloom and 8mL/Gal of GH Micro for the aforementioned result (lucas ratio). Your pH will start around 5.6-5.7. Be careful in the beginning when running 1/4 strength as you run the risk of hurting the babies if you use pH adjusters. When ppm is low , even a small amount of pH up will do a disproportionate (read: wild up swing) amount of work. Try to avoid pH adjusters in the beginning "1/4 strength mode". If you feel the need to raise the pH a little, just use a small amount (1.5mL/Gal) of potassium silicate at the onset ( just once after you change water, not daily as a pH UP replacement) will do.

Originally Posted by problemsolver

Soon as you see the second pair of leaves (not including the embryonic set) go with 1/4 strength. I wouldn't wait much longer otherwise you will leach them a bit and as a result they get a slow start. Ditch the grow and just use the micro and bloom. If your water is close to hard (120-199ppm on a hanna .5 conversion scale, for truncheon multiply that ppm by 1.4) dose 15mL/Gal of GH Bloom and 7.5mL/Gal of GH Micro for full strength ( use 1/4 of that in the beginning) res resulting in 941-1020 ppm (.5 conv.) If your water is relatively soft (35-119ppm, .5 conv.) use 16mL/Gal of GH Bloom and 8mL/Gal of GH Micro for the aforementioned result (lucas ratio). Your pH will start around 5.6-5.7. Be careful in the beginning when running 1/4 strength as you run the risk of hurting the babies if you use pH adjusters. When ppm is low , even a small amount of pH up will do a disproportionate (read: wild up swing) amount of work. Try to avoid pH adjusters in the beginning "1/4 strength mode". If you feel the need to raise the pH a little, just use a small amount (1.5mL/Gal) of potassium silicate at the onset ( just once after you change water, not daily as a pH UP replacement) will do.

Man this is confusing me now! The bottle says on the 3rd week I should start with 2.5mL/10liters (2.64Gallon) and the numbers you are talking about are way much higher, are you sure these numbers are for only 1 gallon reservoir ?

Call them!!!!!! But yes its for 1 gallon

i added 2.5 of everything and got nutrient burn! i flushed it with only bottled water last night hopefully she recovery from the overdose of nutrients