Ive been seeing tons of posts recently of how to wire lights so they can be put into stealth cabs or rubbermaids.

So i was putting together one for a test set up (check out my journal in may) and I wanted to post it so people can use it without reasking

First you need to get the following things:
-a vanity light fixture for a bathroom (can be any amount of bulbs)
-an entension cord (my tip is to use one thats made for broken tools cause its already stripped, they are in the same section as the normal ones)
-light y-inserts
-tons of duck tape
-AND this is important, to have electrical caps (youll see how they work later)

Here are the goods:


Take apart the vanity mirror by taking off the front panel and pulling the 3 wires through the back, there should be a black, white and another one which represents the ground (sometimes different colours)


Next, strip your entension cord and youll notice the exact same black, white wires and a green one (which is the ground)


Just attach each colour to the corresponding one. When you make the connection place the electrical caps on the top of the connection and put a bunch of tape

Tape it all down to the fixture so the wires dont get in the way


Put in the y light fixtures and then youre done, plugger in... as you can see from the last picture make sure you clean everything up to avoid fires


Hope this helps, feel free to leave msgs with questions or PM. Rep+ if ya use it

-Monkee