|
Make sure all excess filings are out of the pipes and the burs cleaned off each end. You will take the pvc glue which has a brush in th can and swab 1 end of each of the 4 10 inch pieces 1 at a time then twisting the end cap onto the end then tap it on the ground seating it firmly.You should have 4 10 inch lengths with caps on 1 end.Next you will use 1 of the 1/2 inch regular T fitting apply the cement to the other end of each of the 4 10 inch pieces 1 at a time.You will slip the end you applied the cement to into the T fitting.Then repeat this with the other 10 inch long pieces using the second regular T fitting tapping them into place tightly with cement on them.You now have 2 lenghths with end caps on each of the ends with a T fitting in the middle of each length.Now using your hack saw cut the 7 1/2 inch pice in half which is 3.75 inches giving you 2 pieces.Next you will need the Threaded 1/2 inch pvc T fitting.Put the pvc cement on 1 end of each of the 2 pieces inserting the glued end into the threaded T fittings non threaded ends.You should now have what looks like a T with an open threaded end on the T fitting.You will now put cement on each of the ends of this new middle bar 1 side at a time.It is important that the threaded opening in the middle is pointing straight down when you glue the 2 ends into each of the 2 longer pipes you made as the thread will go directly to your pump barb.You will now have what looks like an H with the cenetr having a threaded T fitting pointing directly down...
|