Almost there, time to polish it off...... get the pump set dead center (the pumps out flow hole i mean) and connect the mister contraption... Now is a good time to add the Weather stripping to the top rim of the jug, little extra waterproofing, if there are any holes in the handles now is a good time to seal them up too.....



The Black 1/2" irrigation tubbing is way strong enough to hold it all together and heavy enough when full of water to keep the pump in place too, if you use a pump without a suction cup stand you will want to stick it in center with silicon at least one day before you put the mister contraption on it.....

At this stage it is ready for testing.... almost, if ya want water all over the place go ahead! We still got one thing to do..... cut and put the neoprean plugs in!....

I could only find Neoprean plugs that were 1" thick, didn't matter how wide just all were 1" thick.... soo.... i bot a bunch of 2" and proceeded to cut them in half thickness wize, got 2 for 1 and what i needed... he he he ......



So now we take the time and get the plugs cut and put in there respective holes.........

After they are all in place it's time to get the finished cloner in place and filled up....... fill it to the point ware the lowest misters are just outa the water, thats a good full range... if ya fill it with anything less then RO water let it sit for a day before you fire it up... i personally use tap water (all i have) and let it sit for a few days before, but thats just my preference.....

Now we can test the beast......

***** GET WET TIME *****

Get your mister install tool inhand before you fire it up and lift the lid, you'll need it to aim the misters....
now plug in the pump and open the lid.....
use the tool and make sure all the misters are spraying in a full coverage of the hole perimeter, it'll probably take a bit and you'll get wet for sure, but need.....



Time to give yourself a pat on the back, YOU DID IT ..... he he he, and it's just that easy......